To terminate the conference call hang up the phone connected to the router.
I have noise interference during telephone calls. How can I fix this?
To resolve this issue, try the following:
Verify that the RJ-11 cable is securely connected and not damaged.
Try to remove any telephone splitters from the connection between your phone and theNTC-30WV.
Try rebooting your NTC-30WV.
Voice Troubleshooting
What do I do if I have no dial tone?
Please follow the procedure listed below:
1. Check to make sure the phone is plugged into your NTC-30WV on the RJ-11 port (between the power socket and the
LAN port).
2. Check to make sure you are using the correct cable (Cat-3 UTP Telephone Cable with RJ-11 plugs).
3. Check to make sure the “SIM status” shows “SIM OK” on the Status page of the Web interface.
4. Check to make sure your 3G SIM card is activated and insert into your NTC-30WV properly.
5. Check and see if you get the dial tone after rebooting your NTC-30WV.
List of Mobile Broadband Service Provider APNs
To Next Page
Loading...
Need help?
General
