6. Select Settings > Other.
The Other Settings page displays.
CAUTION: After you click the RESET button, do not try to go online, turn off the
extender, shut down the computer, or do anything else to the extender until it finishes
restarting.
7. Click the RESET button.
A confirmation pop-up window opens.
8.
Confirm your decision.
The extender returns to its factory settings and restarts. This process takes about
one minute.
Update the extender firmware
You can log in to the extender and check to see if new firmware is available, or you can
manually load a specific firmware version to your extender.
Check for new firmware and update the extender
Unless you changed the settings in the Firmware Update page previously, the extender
is set up to check for new firmware automatically at login.
To check manually for new firmware and, if available, update the firmware:
1.
Launch a web browser from a computer or mobile device that is connected to your
extender network.
2. Log in to your extender:
•
If you did not enable the One WiFi Name feature, enter
http://www.mywifiext.net/ in the address field of the browser.
•
If you enabled the One WiFi Name feature, enter one of the following URLs:
-
Windows-based computers. http://mywifiext/ or http://mywifiext.local/
-
Mac computers, iOS devices, and Linux devices. http://mywifiext.local/
-
Android devices. http://<extender’s IP address>/ (for example,
http://192.168.1.3/)
For more information about how to find your extender’s IP address, see Find
the Extender’s IP address on page 60.
User Manual53Maintain and monitor the
extender
AX1800 4-Stream WiFi Mesh Extender
To Next Page
Loading...
Need help?
General
Weight and Dimensions
