NETGEAR RT311 User Manual

Troubleshooting 11-1
Chapter 11
Troubleshooting
This chapter gives information about troubleshooting your Model RT311 or RT314 Internet
Access Gateway Router. After each problem description, instructions are provided to help you
diagnose and solve the problem.
Basic Functioning
After you turn on power to the router, the following sequence of events should occur:
• The PWR LED lights.
• The router performs a self-test for 30 seconds, during which the Test LED should blink at a
rate of about 0.5 Hz and then turn off.
• If the Local and Internet Ethernet connections are correctly made to operational devices, each
LNK/ACT LED should be on.
• If a Local Ethernet port is connected to a device that operates at 100 Mbps, the 100 LED
should be on.
If any of these conditions does not occur, refer to the appropriate following section.
PWR LED Not On
If the PWR and other LEDs are off when your router is turned on:
• Make sure that the power cord is properly connected to your router and that the power supply
adapter is properly connected to a functioning power outlet.
• Check that you are using the 12 V DC power adapter supplied by NETGEAR for this product.
If the error persists, you have a hardware problem and should contact technical support.

NETGEAR RT311 Specifications

General

Brand	NETGEAR
Model	RT311
Category	Network Router
Language	English