Reference Guide for the Model RT311 and RT314 Internet Access Gateway Routers
6-4 Maintenance
DHCP Table
The DHCP Table shows all IP address assignments that have been made by the router’s DHCP
server. From the Main Menu of the browser interface, click on Maintenance, then select DHCP
Table to view the table, shown in Figure 6-3
Figure 6-3. DHCP Table
For each PC client, the table shows the IP address, Ethernet MAC address, and NetBIOS Host
Name. Note that if the router is rebooted, the table data is lost until each PC renews its DHCP
lease.
Software Upgrade
The routing software of the Model RT311 and RT314 routers is stored in FLASH memory, and can
be upgraded as new software is released by NETGEAR. Upgrade files can be downloaded from
Netgear's website. If the upgrade file is compressed (.ZIP file), you must first extract the binary
(.BIN) file before sending it to the router. The upgrade file can be sent to the router using your
browser.
Note:
The Web browser used to upload new firmware into the Model RT311 and RT314 routers
must support HTTP uploads. NETGEAR recommends using Netscape Navigator 3.0 or above.
To reach the Upgrade menu, click Maintenance from the navigation bar on the left, and then click
the Upgrade heading. To upload new firmware:
1.
Download and unzip the new software file from NETGEAR.
2.
In the Software Upgrade menu, click the Browse button and browse to the location of the
binary (.BIN) upgrade file
3.
Click Upload.
To Next Page
Loading...
Need help?
General
