Not all accessories are available on all markets.
Auxiliary relay HR 10
Auxiliary relay HR 10 is used to control external 1 to 3 phase
loads such as oil burners, immersion heaters and pumps.
Part no 067 309
Base extension EF 45
This accessory is used to create a larger connection area
under F1226.
Part no. 067 152
Buffer vessel UKV
UKV 200
Part no. 080 300
UKV 100
Part no. 088 207
Exhaust air module FLM
FLM is an exhaust air module designed to combine recovery
of mechanical exhaust air with ground-source heating.
Bracket pack FLM
Part no. 067 083
FLM
Part no. 067 011
Extra relay card EXC 40
Extra relay board required if ground water pump and/or
hot water circulation pump is to be connected to F1226.
The extra relay card is installed inside the heat pump.
Part no. 067 072
Filling valve kit KB 25
Valve kit for filling brine in the collector hose. Includes
particle filter and insulation.
KB 25 (max. 12 kW)
Part no 089 368
Level monitor NV 10
Level monitor for extended checks of the brine level.
Part no. 089 315
Load monitor EBV 200
EBV 200 is a two-stage electronic load monitor used to
disconnect output that exceeds the output set on the load
monitor.
Part no. 418 346
Room sensorRTS 40
This accessory is used to obtain a more even indoor temper-
ature.
Part no. 067 065
47Chapter 11 | AccessoriesNIBE F1226
11 Accessories
To Next Page
Loading...
Need help?
General
