in the “Intended use” section. Any improper use could result in risks
to life and limb of the operator or third parties and could affect the
condition of the device and other property. Accidents or near-acci
-
dents arising during the use of the device which have resulted, or
might have resulted, in personal injury and/or damage to the working
environment must be reported to the manufacturer directly and im
-
mediately.
Allsafetyinformationspeciedintheinstallationinstructionsandon
the device must be adhered to. In addition to this safety information,
the operator must ensure that all national and international regulations
applicable in the respective country of use, as well as other binding
regulations relating to operational safety, accident prevention and
environmental protection, are complied with. All work on the device
must be performed only by trained and authorised personnel who
have been instructed on safety.
2.3 GENERAL DUTIES OF THE PLANT OPERATOR
– The operator is obligated to use the device only when it is in
perfect working order and is safe to operate. The operator
must ensure that, in addition to the safety information in the
installation instructions, the generally accepted safety and
accident-prevention regulations, the specications of DIN
VDE 0100 and the provisions relating to environmental pro
-
tection of the respective country of use are observed and
complied with.
– The operator is responsible for ensuring that all work with
device is carried out only by appropriately trained and au
-
thorised personnel who have been instructed on safety.
– The operator of the device, or personnel authorised by the
operator, bear(s) ultimate responsibility for ensuring acci
-
dent-free operation.
– The operator is responsible for ensuring compliance with
the technical specications and in particular compliance
with the static loads.
Non-compliance with the static loads may cause loss of
the support or holding function.
2.4 PERSONNEL REQUIREMENTS
– Any person commissioned with performing work on the de-
vice must have read through and understood the operating
instructions completely before performing the correspond
-
ing work. This also applies if the person concerned has pre-
viously worked with such a device or has been trained to
do so.
– All work on the device must be performed only by trained
and authorized personnel who have received safety in
-
struction. Before starting any operations, personnel must be
made aware of the dangers involved in handling the device.
– Personnel may only perform work for which they are qual
-
ied. The responsibilities of each person must be clearly
dened.
– Any personnel commissioned with working on the device
must have no physical limitations that could temporarily or
permanently impair their attentiveness or judgement (e.g.
due to excessive fatigue).
– Minorsorpersonsundertheinuenceofalcohol,drugsor
medication are prohibited from working with the device and
performing any installation, dismantling or cleaning work.
– Personnel must wear personal protective equipment appro
-
priate to their job and their working environment.
2.5 SAFETY INFORMATION ON THE TECHNICAL
CONDITION
– The device must be checked for damage and correct oper-
ation before installation.
– The operator is obligated to operate the device only when it
is in perfect working order and is safe to operate. The tech
-
nical condition must comply with the legal requirements at
all times.
– If dangers to personnel or changes in operating behaviour
areidentied, the devicemust be shutdown immediately
and the incident reported to superiors or the operator.
– The device may only be connected to the energy supply
6 – ENGLISH
EN
To Next Page
Loading...
Need help?
General
