Squeegee System 90Service Manual – SC2000
Checking/Replacing the Squeegee Blades
Note: The squeegee must be clean and its blades must be in good conditions in order to get a
good drying.
Warning! It is advisable to wear protective gloves when cleaning the squeegee because there
may be sharp debris.
1. Clean the squeegee as shown in the previous
paragraph.
2. Check the condition of the front (C, Figure 3)
and rear (D) blades, ensuring there are no cuts
and tears; if necessary, replace them as shown
below. Check that the front corner (E) of the rear
blade is not worn; otherwise, turn the blade to
replace the worn corner with one of the three
remaining intact corners. If the other corners
are worn too, replace the blade according to the
following procedure:
◦ Using the tab (F), release and remove the
elastic strap (G) from the fasteners (H), then
turn or replace the rear blade (D).
◦ Install the blade in the reverse order of re-
moval.
◦ Unscrew the handwheels (I) and remove the
strap (J), then turn or replace the front blade
(C).
◦ Install the blade in the reverse order of re-
moval.
3. Install the squeegee on the support and screw
down the handwheels.
4. Lower the squeegee to the oor to check the
height of the blades, proceeding as follows:
◦ Check that the lip (K) of the front blade (C)
and the lip (L) of the rear blade (D) are rest-
ing as shown in the gure.
◦ Use the knob to make adjustments.
I
D
C
G
KEL
D
C
J
J
H
F
G
F
I
Figure 3
To Next Page
Loading...
Need help?
General
