Scrub System, Disc 83Service Manual – SC3000
Maintenance and Adjustments
Brush/pad-holder installation/removal
1. Insert the ignition key and turn it to “I”.
Warning! Before pressing the scrub On/Off push button , always check that, between the
deck and the machine there is no foreign material which may prevent the deck from
lifting.
2. Lift the deck by pressing the scrub On/Off push button .
3. Turn the ignition key to “0”.
4. Install the brushes (A) or pad-holders (B or C) in the drive hub (D) under the deck, then turn them in
the opposite direction to their rotation direction, until they reach the end of stroke (E).
5. To remove the brushes/pad-holders perform steps 1 to 3, then manually release the brush/pad-holder
from the hub by turning it abruptly in its normal rotation direction (F).
Warning! If the machine is not perfectly assembled it can cause damages to people and
properties. Always check that all components are assembled before starting the
machine. Carefully inspect the machine before using it.
Front
Front
A
D
D
E
E
F
F
A
D
D
E
E
B
B
C
C
F
F
P100362
To Next Page
Loading...
Need help?
General
