13
English
w
w
w
.novasina.com
• Button [Actual/Stable]: Switchover of the display
o A switchover is made between the actual measurement values
and the stored stable value.
• Button [Actual/Stable] (push button for a longer time): Information display
o On the upper line of the info display, the measurement
number, which is used for the definition of the data name on
the SD-card is displayed.
o On the lower line the time since the start of the measurement
(actual) or the time until reaching the stability is displayed
(from 99:59:59h, —.—.— is displayed).
• Button [Menu]: Switch to configuration menu
o The various parameters are explained in the next chapter.
o The configuration menu can be quit at any time by pushing
the [Menu] button for a longer time.
• Button [Menu] (push button for a longer time): Switch off the device
o With this function all SD-card data are closed and the system
is shut down.
Note:
The instrument should not be switched off by just pulling out the power plug,
as otherwise problems with the SD-card (file system) may happen.
4.2. Configuration menu
By pushing the button [Menu] you get to the configuration menu, where you can
select the single menu points using the button (up) (down). Following the menu
points are described in detail.
4.2.1. Submenu „SD-Eject“ - „M EJECT“
SD-card data files are closed, so that the card can be taken out. The display
symbol „SD rec“ disappears and the SD-card can be removed safely.
Note :
Do not take out the SD-card whilst the SD symbol is displayed.
To Next Page
Loading...
Need help?
General
