23
English
w
w
w
.novasina.com
Factory setting
" 8808 "
We recommend to start a new calibration with the SAL-T 75%. After that go
up to 84% and 90% and than forward with 58%, 33% and finally11%. This
procedure is reliable.
Novasina offers additional SAL-T humidity standards which are not included
in the delivery. Further information are provided by your official Novasina
dealer or on
www.novasina.com .
6.3. Clear Calibration Points
This function clears all calibration points, which are irrevocably saved on the
measuring sensor. If a calibration point was calibrated wrong a single or all
calibration points can be cleared. The function is performed when you enter the
menu:
„* CALIB“ -> „CAL CLR““. By selection of the adequate menu point the
function is carried out.
6.4. Set Sensor Password
Every sensor unit CM-2 Sensor has the possibility to protect the internal
calibration points by a password. This prevents the sensor to be adjusted by
unauthorized or not qualified persons. If a sensor password is set (factory
setting „8808“) it has to be entered for the calibration of one or more calibration
points. A forgotten password can only be set back at the factory.
The measuring sensor can be protected under the menu point „SET PSW“ by
a 4-digit numerical code. This code is directly stored on the sensor.
If the password is set, it will be required before the changing of the calibration
data or for the modification (clear) of the calibration values.
To deactivate the password protection the settings can be set on „0000“.
TIP:
Store the password on a secured place!
Attention :
A forgotten password means to send the sensor or the instrument
back to Novasina (Switzerland). There is no way to reset the sensor!
To Next Page
Loading...
Need help?
General
