6
English
w
w
w
.novasina.com
2.2. System Architecture
The LabSwift-aw consists of modular assemblies in combination with the
unique resistive electrolytic Novasina measurement technology, which is built
inside the aW sensor. The aW measurement signal is electronically processed
together with the IR (infrared) measurement and an additional temperature
measurement. Afterwards it is further processed by a high capacity micro
controller. This is handling the LCD display unit and stores data on an external
removable SD-card. The mains are supplying the whole electronics with
power.
The LabSwift-aw does not dispose of an internal temperature control, but has
a surface temperature sensor based on an infrared measurement. For che-
cking and adjusting the aW values, humidity standards (see chapter 6) can be
used.
2.3. Overview
2.3.1. Function keys
Each function key has 3 markings. On top the measurement mode function
(standard operation). The central mark shows the configuration menu function.
The lower, green symbol shows the function, which can be selected by pressing
the key during the measurement mode (approx. 1s).
2.3.2. Function key < Menu >
Measurement mode
- With this key the device is switched on
- Access to menu
- Device is switched off if pressed for a long time
Menu mode
- Carries out the selected function or enables the parameter setting
- Adapts the set parameters
- By pressing for a long time you get from each menu point directly to the
measurement mode
To Next Page
Loading...
Need help?
General
