Safety
NVIDIA DGX A100 DU-09821-001 _v01|94
‣
The power supply cord(s) must be plugged into socket-outlet(s) that is /are provided
with a suitable earth ground.
B.7. System Access Warnings
Here is some information about system access warnings for the DGX A100 system.
To avoid personal injury or property damage, the following safety instructions apply whenever
accessing the inside of the product:
‣
Turn off all peripheral devices connected to this product.
‣
Turn off the system by pressing the power button to off.
‣
Disconnect the AC power by unplugging all AC power cords from the system or wall outlet.
‣
Disconnect all cables and telecommunication lines that are connected to the system.
‣
Retain all screws or other fasteners when removing access cover(s). Upon completion of
accessing inside the product, refasten access cover with original screws or fasteners.
‣
Do not access the inside of the power supply. There are no serviceable parts in the power
supply.
‣
Return to manufacturer for servicing.
‣
Power down the server and disconnect all power cords before adding or replacing any non
hot-plug component.
‣
When replacing a hot-plug power supply, unplug the power cord to the power supply being
replaced before removing the power supply from the server.
CAUTION: If the server has been running, any installed processor(s) and heat sink(s) may
be hot.
Unless you are adding or removing a hot-plug component, allow the system to cool before
opening the covers. To avoid the possibility of coming into contact with hot component(s)
during a hot-plug installation, be careful when removing or installing the hot-plug
component(s).
CAUTION: To avoid injury do not contact moving fan blades. Your system is supplied with a
guard over the fan, do not operate the system without the fan guard in place.
B.8. Rack Mount Warnings
The following installation guidelines are required by UL to maintain safety compliance when
installing your system into a rack.
The equipment rack must be anchored to an unmovable support to prevent it from tipping
when a server or piece of equipment is extended from it. The equipment rack must be
installed according to the rack manufacturer's instructions.
To Next Page
Loading...
Need help?
General
