Operating manual X9 Series metering pumps
File: UT-4336 – Rev.0 Copyright © - OBL Metering pumps - All rights reserved Page 5
GB
Although the X9 pumps include different and widely different models (see "Identifying code" and "Technical data"), the technical
information contained in this instructions manual are equally appropriate and applicable (except where expressly stated) for any
pump containing "X9" in its code.
OBL reserves the right to modify the characteristics of its products at any time to apply the latest technological innovations. The
information contained in this document is therefore subject to change without notice.
2.1 PERSONNEL RESPONSIBLE FOR MACHINE OPERATION
Personnel, before operating the machine, must be professionally trained (preferably an employee of the sector) and must have read
and understood the instructions contained in this manual.
The employer must instruct all staff on the risks of accidents and on devices and clothing to be used for individual safety, on the risks
arising from noise emission and on general provisions laid down by European Directives and legislation in the country of machine
installation.
2.1.1
"Operator" personnel
The term "Operator" is intended as personnel that carry out the following tasks on the machine:
- performs the functions needed for operation
- uses the adjustment and operating commands
- performs simple actions related to operation
- performs any cleaning and daily inspection operations
- reports defects or machine malfunctioning
The operator must work on the machine while protective guards are mounted and safety devices active
2.1.2
"Mechanical Maintenance" personnel
Intended as personnel that operates on the machine in all operating conditions and at all protection levels.
Performs all types of repairs or mechanical adjustments but does not work on electrical installations.
2.1.3
"Electrical Maintenance" personnel
Intended as personnel that operates on the machine in all operating conditions and at all protection levels.
Performs all types of repairs or electrical installations adjustments, even in the presence of voltage.
2.2 TESTING AND GUARANTEE
2.2.1
Testing
Each OBL metering pump is a reliable quality product, subject to careful final inspection to ensure their proper functioning and found
compliance with the specified performance. The final test results, if specifically requested by contract, are registered in special forms
and made available to the Customer. Pump which successfully pass the final tests is then labelled with a green sticker applied on the
product by the testing supervisor.
2.2.2
Guarantee
Metering pumps, as with all other OBL products, are guaranteed for a period of twelve (12) months of operation but in any case no
longer than eighteen (18) months from the date of delivery (document of transport refers).
The guarantee covers the replacement, free of charge and ex-factory in Segrate (MILANO) ITALY, of any component found to be
defective in material or processing by the OBL technical office.
The guarantee IS NOT VALID in the following cases:
- components subject to normal wear (e.g. gaskets, seals, O-rings);
- if installation and/or use do not meet the technical conditions of sale and instructions;
- if the pump has been tampered with or disassembled;
- if the pump has been sold to third parties.
ATTENTION: Always avoid disassemble or attempted repair of products still under guarantee, as doing so will
void the guarantee. Always contact OBL customer service for information.
In the case of a guarantee claim, the pump must be sent postage paid to the OBL factory in Segrate (MILANO) ITALY, accompanied by
a description of the anomaly complained.
For safety reasons BEFORE shipping, the sender MUST ALWAYS contact OBL customer service (Tel. +39-02-26919.1, info@obl.it)
and operate as indicated in point "Instructions for returning goods in OBL".
To Next Page
Loading...
Need help?
General
