Oki MC352 User Manual

- 74 -
Scanning to Local PC
4
Scanning
 For Network Connection
To congure the Scan to Local PC function via
the network connection, follow the 2 steps
below:
● “Step 1 Conguring the Network Settings of
Your Machine” P.74
● “Step 2 Installing Driver and Software” P.77
Note
● You need to congure the network setting of the computer
before this procedure.
Memo
● You can skip step 1 if the IP address is already set on your
machine.
● You can skip step 2 if the scanner driver and ActKey are
already installed on your computer.
 Step 1 Conguring the Network
Settings of Your Machine
Connect your machine to a network with an
Ethernet cable, and then congure the machine’s
IP address and other network information from
the operator panel. You can set the IP address
either manually or automatically.
If there is no DHCP server or BOOTP server on
the network, you need to manually congure the
IP address on the computer or machine.
If your network administrator or internet
service provider species a unique IP address
for the computer and your machine, set the IP
addresses manually.
Note
● When setting an IP address manually, ask the network
administrator or your internet service provider which IP
address to use. If the IP address is set incorrectly, the
network may go down or Internet access may be disabled.
● To congure the Scan to Local PC function via the network
connection, follow these instructions.
- Conform the IP version of the machine to that of your
computer.
- Set [TCP/IP] setting to [Enable] on your machine.
(By factory default, it is set to [Enable].)
- Set [Network TWAIN] setting to [ON] on your
machine. (By factory default, it is set to [ON]. If
it has been disabled, enable it by referring to the
Conguration Guide > “Conguring the scanning
to Local and Remote PCs” > “Using Functions for
Scanning to Local and Remote PCs” > “Enabling the
Network TWAIN Setting”.)
Memo
● If conguring a small network consisting of only your
machine and a computer, set IP addresses as shown
below (according to RFC1918).
For the computer
IP address : 192.168.0.1~254
Subnet mask : 255.255.255.0
Default gateway : not used
DNS server : not used
For the machine
IP Address Set : Manual
IPv4 Address : 192.168.0.1~254
(select a different value
from the computer)
Subnet Mask : 255.255.255.0
Gateway Address : 0.0.0.0
Network Scale : Small
● To set [Network Scale], press the <SETTING> key
and then select [Admin Setup] > [Network Menu] >
[Network Setup] > [Network Scale].
1 Prepare an Ethernet cable and a hub.
Prepare an Ethernet cable (category 5, twisted
pair, straight) and a hub separately.
2 Hold down the power switch for
approximately one second to turn off the
power.

Oki MC352 Specifications

General

Brand	Oki
Model	MC352
Category	All in One Printer
Language	English