Oki Microline 3320 User Manual

CHAPTER 3 SPECIAL CSF OPERATING SITUATIONS
When the Cut-Sheet Feeder is installed, any paper in the start position will
be ejected whenever the printer is turned or initialized.
Entering
the Menu Select Mode
1. Be sure that paper is loaded in the CSF tray.
2. Press the SHIFT+ MENU button.
It doesn't matter whether or not paper is in the printing position. If it isn't,
the CSF will automatically feed in a sheet.
Printing
the Self Test
1. Be sure that paper is loaded in the tray, but NOT in the print position.
(If paper
is in the print position, press the FF/LOAD button to eject it.)
2. Initiate the self test by using one of the following methods:
(a) Press the LF button while turning on the printer. The CSF will
insert a sheet of paper, produce one full page containing a sample
of available print styles, and eject the sheet to the stacker.
(b) Press the QUIET button while turning on the printer. CSF will
insert a sheet of paper and produce a continuous sample of the
default style print. It will then eject the sheet, insert a new one
and resume printing. This
will continue until you press the SEL
button, which stops the printer and ejects the paper.
ML3320id8.indd33ML3320id8.indd33 2015/05/0817:542015/05/0817:54
プロセスシアンプロセスシアンプロセスマゼンタプロセスマゼンタプロセスイエロープロセスイエロープロセスブラックプロセスブラック

Oki Microline 3320 Specifications

General

Print Technology	Impact Dot Matrix
Emulations	Epson FX, IBM ProPrinter
Resolution	240 x 216 dpi
Print Resolution	240 x 216 dpi
Print Speed	435 cps
Connectivity	Parallel, USB
Paper Handling	Continuous paper
Number of Pins	9
Paper Width	76.2 - 254 mm
Noise Level	57 dBA