Distance to Destination
This feature acts as a reverse trip odometer by counting
backward from an estimated distance which you enter
before starting your trip. It also uses that information to
determine the estimated time
of
arrival.
To
set, press DEST, then RESET and enter a maximum
of
four digits for the length of your trip. (Always use
whole miles or kilometers.) Then press ENTER. The
system will only accept the last four digits you enter as
your distance to destination.
The system will display the total distance to destination,
such as:
365
MI
TO
DEST
or
587
KM TO DEST
When the system counts down to zero distance
remaining, even if you’re in another display, a chime
will sound and the display will show:
TRIP COMPLETE
The TRIP COMPLETE message will
go
off when you
press any button, or when you turn your ignition to
OFF,
then on. The display returns to the mode displayed prior
to the interruption.
Estimated Time
of
Arrival (ETA)
ETA is based on the average speed, the date and time
of
the day, and the estimated distance
to
your destination.
After you have entered your distance to destination,
press ETA to display estimated time of arrival, such as:
ETA TUE
1256
PM
Press ETA again
to
display the time to destination. The
display will show the current time as the hours and
minutes to destination, such as:
1250
TIME TO DEST
If
the
time to destination calculation
is
seven days or
greater, the display will read:
TRIP OVER
7
DAYS
When the trip is complete a chime will sound and the
display will show:
TRIP COMPLETE
The trip complete message will
go
off when you press
any button,
or
when you
turn
your ignition off, then on.
The display returns to the mode displayed prior to
the interruption.
2-84
To Next Page
Loading...
Need help?
General
