Turn
and Lane Change Signals
n
The turn signal has two upward (for right) and two
downward (for left) positions. These positions allow you
to signal a turn or a lane change.
To
signal a
tum,
move the lever all the way up or down.
When the
turn
is finished, the lever will return automatically.
An arrow
on
the instrument
panel will
flash
in
the
direction of the turn
or
lane change.
To signal a lane change, just raise or lower the lever
until the arrow starts to flash. Hold it there until you
complete your lane change. The lever will return
by
itself when you release it.
As
you signal
a
turn
or a lane change, if
the
arrows don’t
flash but just stay
on,
a signal bulb may be burned out
and other drivers won’t see your turn signal.
If a bulb is burned out, replace it to help avoid
an accident.
If
the arrows don’t
go
on at all when you signal a turn,
check the fuse (see “Fuses and Circuit Breakers” in the
Index) and for burned-out bulbs.
2-36
To Next Page
Loading...
Need help?
General
