Windshield Wipers
The lever on the right side of your steering column
controls your windshield wipers.
For a single wiping cycle, move the lever up to MIST.
Hold
it
there until the wipers start, then let go. The
wipers will stop after one cycle.
If
you want more
cycles, hold the lever to
MIST
longer.
For steady wiping at low speed, push the lever down to
the
LO
position. For high-speed wiping, push the lever
down further, to HI. To stop the wipers, move the lever
to
OFF.
You
can set the wiper speed for a long or short delay
between wiper cycles. This can be very useful in light
rain or snow. Push the lever down
to
the first detent,
DELAY.
Turn the band closer to the short lines for fewer
wiper passes per minute.
As
you turn the band toward
the long lines, the wiper cycles per minute will increase.
Remember that damaged wiper blades may prevent you
from
seeing well enough to drive safely. To avoid damage,
be sure to clear ice and snow from the wiper blades before
using them.
If
they’re frozen to the windshield, carefully
loosen or thaw them.
If
your blades do become damaged,
get new blades or blade inserts.
Heavy snow or ice can overload your wipers.
A
circuit
breaker will stop them until the motor cools. Clear away
snow or ice to prevent an overload.
2-39
To Next Page
Loading...
Need help?
General
