Care of Safety Belts
Keep belts clean and dry.
A
CAUTl
a
a
Do
not bleach or dye safety belts. If you do, it
may severely weaken them. In a crash, they
might
not
be able to provide adequate protection.
CIean safety belts only with mild soap and
lukewarm water.
Cleaning Glass Surfaces
Glass should be cleaned often. GM Glass Cleaner (GM
Part
No.
1050427) or a liquid household glass cleaner
will remove normal tobacco smoke and dust films on
interior glass.
Don’t use abrasive cleaners on glass, because they may
cause scratches. Avoid placing decals on the inside rear
window, since they may have to be scraped off later. If
abrasive cleaners are used
on
the inside
of
the rear
window, an electric defogger element may be damaged.
Any temporary license should not be attached across the
defogger grid.
Cleaning the Outside
of
the
Windshield and Wiper Blades
If the windshield is not clear after
using
the windshield
washer, or if the wiper’ blade chatters when running,
wax, sap or other material may be on the blade
or windshield.
Clean the outside of the windshield with GM Windshield
Cleaner, Bon
Ami@
Powder (non-scratching glass cleaning
powder),
GM
Part
No.
105001
1.
The windshield is clean
if
beads
do
not form when you rinse it with water.
Grime from the windshield will stick to the wiper blades
and affect their performance. Clean the blade by wiping
vigorously with a cloth soaked in full-strength
windshield washer solvent. Then rinse the blade
with water.
Check the wiper blades and clean them as necessary;
replace blades that look worn.
Weatherstrips
Silicone grease on weatherstrips will make them last
longer, seal better, and not stick or squeak. Apply
silicone grease with a clean cloth at least every six
months. During very cold, damp weather more frequent
application may be required. (See “Recommended
Fluids
and
Lubricants’’ in the Index.)
To Next Page
Loading...
Need help?
General
