Don’t use any of these unless this manual says you can.
In many uses, these will damage
your
vehicle:
Alcohol
Laundry Soap
Bleach
Reducing Agents
Cleaning the Inside
of
Your Aurora
Use a vacuum cleaner often to get rid
of
dust and loose
dirt. Wipe vinyl or leather with a clean, damp cloth.
Your Aurora retailer has two cleaners, a solvent-type
spot lifter and a foam-type powdered cleaner. They will
clean normal spots and stains very well. Do not use
them on vinyl or leather.
Here are some cleaning tips:
1.
2.
3.
4.
Always read the instructions on the cleaner label.
Clean
up
stains as soon as you can
--
before they set.
Use a clean cloth or sponge, and change to a clean
area often. A soft brush may be used
if
stains
are stubborn.
Use solvent-type cleaners in
a
well-ventilated area
only. If
you
use them, don’t saturate the stained area.
5.
If a ring forms after spot cleaning, clean the entire
area immediately or it will set.
Using
Foam-Type Cleaner
on
Fabric
1.
2.
3.
4.
5.
6.
7.
8.
9.
Vacuum and brush the area to remove any loose dirt.
Always clean a whole trim panel or section. Mask
surrounding trim along stitch or welt lines.
Mix Multi-Purpose Powdered Cleaner following the
directions on the container label.
Use suds only and apply with a clean sponge. Don’t
saturate the material and don’t rub
it
roughly.
As soon
as
you’ve cleaned the section, use a sponge
to
remove the suds.
Rinse the section with a clean, wet sponge.
Wipe off what’s left with a slightly damp paper towel
or
cloth.
Dry it immediately with
a
blow dryer.
Wipe with a clean cloth.
To Next Page
Loading...
Need help?
General
