EC- DECLARATION OF CONFORMITY
under Annex II.A of the 2006/42/EC Directive on Machines
DECLARES
Under his sole responsibility that the machine TURNTABLE MACHINE WITH
AUTOMATIC WORKING CYCLE designed for winding pallet loads with extensible film
Model:
Omni BASE
IS IN CONFORMITY with the following provisions:
- European Community Directive 2006/42/EC – on the safety of machines;
NOTE: the Directive 2006/46/EC replaced the Directive 98/37/EC and its amendments
- European Community Directive 2014/30/EU and amendments – on Electromagnetic Compatibility;
NOTE: the Directive 2014/30/EU replaced the Directive 2004/108/EC and its amendments
- National decrees that implement the Community Directives mentioned above.
List of the Harmonized Technical Rules applied:
Safety of machinery -- General principles for design – Risk assessment and risk
reduction.
Electrical equipment of the machines Part 1: General requirements
Electromagnetic compatibility (EMC) – Part 6-2: Generic standards – Immunity for
industrial environments
Electromagnetic compatibility (EMC). Generic standards. Emission standard for industrial
environments
With a view
to continuous improvement of this machine’s functions, some of its components and/or
characteristics could be modified without notice and without prejudice to the validity of this
document. If differences are found between the contents of this manual and the actual machine
operation, please communicate them to the Builder.
CEC BASE IGM REV13 3
Omni Group Pty Ltd
15-23 Logistics St
Keilor Park, VIC 3042 Australia
Phone: 1300 764 963
Web: www.omnigroup.com.au
E-mail: sales@omnigroup.com.au
To Next Page
Loading...
Need help?
General
