CHAPTER 4
TRANSPORT AND INSTALLATION
4.1 HANDLING AND TRANSPORT
Except different recommendations the machine can be handled with fork-lift trucks as shown in the
pictures below.
- During handling the machine must be kept as close as possible to the ground.
- Before using the means of transport check their efficiency and their safety systems.
- Check that the carrying capacity of the means of transport is adequate to the machine mass.
- Check that the size of the passage-ways is compatible with the size of the machine.
- Carry the packed machine as near as possible to the installation place.
If
made necessary by usage and premises equipment, highlight the layout of forklift traffic routes
with pictograms on the plant surface, to ensure workers’ safety.
Dur
ing handling, the machine must always be in a stable and safe position.
While lifting and moving the machine, use maximum caution to avoid dangerous movements, that
may cause incidents or damage to persons or property.
Machine handling must always be carried out by experienced staff.
While lifting and handling the machine, the whole area surrounding it must be considered
DANGEROUS ZONE. Therefore, make sure that there are no people exposed to danger in
the zone.
CEC BASE IGM REV13 33
To Next Page
Loading...
Need help?
General
