Omron 3G3RX2-A2 Series User Manual

4 DriveProgramming Editor
4 - 2
DriveProgramming User’s Manual (I622-E1)
4-1 Starting DriveProgramming Editor
To create DriveProgramming programs, you use the DriveProgramming Editor in the support tool for
the Inverter/Servomotor, CX-Drive.
This section explains the configuration of the DriveProgramming Editor in the CX-Drive and the opera-
tions you carry out before starting the DriveProgramming Editor.
Precautions for Correct Use
• The DriveProgramming function is included in the following or higher versions of the CX-Drive.
If the version of your CX-Drive is lower, you need to upgrade the version.
Version 3.0 or higher (with version 2.9 or lower, operation is not possible.)
• A password is required when you start the DriveProgramming Editor in the CX-Drive for the
first time.
Please contact your OMRON representative.
The DriveProgramming Editor is included as one of the functions of the support tool for the Inverter/Ser-
vomotor, CX-Drive. When the DriveProgramming Editor is started, the screen layout of the CX-Drive
will be changed as shown below.
CX-Drive and DriveProgramming Editor Screen Layout
Workspace DriveProgramming area
Toolbar
Block Parameters
window
Properties window
Toolbox window
Status bar Error List tab Output window

Omron 3G3RX2-A2 Series Specifications

General

Brand	Omron
Model	3G3RX2-A2 Series
Category	Inverter
Language	English