To Next Page

To Previous Page

118

Initial Setting Level Section 5-6

5-6 Initial Setting Level

This level is used to set up the basic Temperature Controller specifications. In

this level, you can set the “input type” parameter to set the sensor input to be

connected, limit the setting range of set points, set the alarm modes, and per-

form other operations.

To move from the operation level to the initial setting level, press the O key

for at least 3 seconds with any parameter displayed except for the “auto/man-

ual switch” parameter.

• The initial setting level is not displayed when the “initial/communications

protect” parameter is set to 2. It can be used when the “initial/communica-

tions protect” parameter is set to 0 or 1.

• If the “input type” parameter is set for an analog input, the following

parameters will be set: Scaling upper limit, Scaling lower limit, and Deci-

mal point.

Operation

Level

Initial Setting

Level

Control stops.

Power ON

Control in progres

Control stopped

100

Press the O Key

for at least 1 s.

Press the

O Key

for at

least 1 s;

display

will flash.

Press the O Key for at

least 3 s.

Omron E5CZ User Manual

Other manuals for Omron E5CZ