Omron V7 Quick Manual

EN-14
6. Full parameter list
Parameter
No.
Description Factory
Setting
n001 Parameter Access 1
n002 Control Mode Selection 0
(Note1, 4)
n003 RUN Command 0
n004 Frequency Reference
Selection
1
n005 Stopping Method Selection 0
n006 Reverse Run Prohibit 0
n007 Stop Key Selection 0
n008 Frequency Reference
Selection in Local Mode
1
n009 Frequency Reference Setting
Method From Digital Operator
0
n010 Detecting Fault Contact of Digi-
tal Operator
0
n011 Max. Output Frequency 50.0Hz
n012 Max. Voltage 200V
(Note 2)
n013 Max. Voltage Output
Frequency
50.0Hz
n014 Mid. Output Frequency 1.3Hz
(Note 4)
n015 Mid. Output Frequency
Voltage
12.0V
(Note 2,4)
n016 Min. Output Frequency 1.3Hz
(Note 4)
n017 Min. Output Frequency
Voltage
12.0V
(Note 2,4)
n018 Selecting Setting Unit for
Acceleration/deceleration Time
0
n019 Acceleration Time 1 10.0s
n020 Deceleration Time 1 10.0s
n021 Acceleration Time 2 10.0s
n022 Deceleration Time 2 10.0s
n023 S-curve Selection 0
n024 Frequency Reference 1
(Master Frequency Reference)
6.00Hz
n025 Frequency Reference 2 0.00Hz
n026 Frequency Reference 3 0.00Hz
n027 Frequency Reference 4 0.00Hz
n028 Frequency Reference 5 0.00Hz
n029 Frequency Reference 6 0.00Hz
n030 Frequency Reference 7 0.00Hz
n031 Frequency Reference 8 0.00Hz
n032 Jog Frequency 6.00Hz
n033 Frequency Reference Upper
Limit
100%
n034 Frequency Reference Lower
Limit
0%
n035 Setting/displaying Unit Selec-
tion for Frequency Reference
0
n036 Motor Rated Current (Note 3)
n037 Electronic Thermal Motor
Protection Selection
0
n038 Electronic Thermal Motor Pro-
tection Time Constant Setting
8min
n039 Selecting Cooling Fan
Operation
0
n040 Motor Rotation Direction 0
n041 Acceleration Time 3 10.0s
n042 Deceleration Time 3 10.0s
n043 Acceleration Time 4 10.0s
Parameter
No.
Description Factory
Setting
I43-EN-01+V7+Quick_Guide.book Seite 14 Dienstag, 25. April 2006 8:56 08

Omron V7 Specifications

General

Brand	Omron
Model	V7
Category	Inverter
Language	English