Onan CCK Series User Manual

POS1TlON MOUN:Tf!llG BOLTS IN
CLEATS PLACED ACROSS FORM ..i:;;liiiliJ'il!""'"
fO INST A LLATION
~
..
'- ' ,'.
,~,,;
BOLT
....
~" ",
FIG. 3 -MOUNTINGBASE
support 8 inches apart~Front cent~r to rear center mounting distance
is 15....;1/8 inches. Be .sure the mounting base is smooth and level so as
toav,oidexcessive strain on any one of the four mountingfeet.
. .
MOUNTING ClTSmONS. - :1nstaU the mounting cushions .asillustrated.
. The metal spacer and the fIat w.asher at each
.end,
p:r~vents excessive.compl'€ssion of the rubber cushions~
\ - ..
EXHAUST. -Pipe the exhaust gases outside the enclosure, using 1 inch
pipe
or larger .. Increase the pipe size used, one siz.e for
each additional 10 feet .in distance. Avoid sharp bends if possible by
uSingbentpipe.or sweeping elbow. where necessary. Connect ihefIex-
ible exhaust tube to thepJant exhaljstoutlet, . Ii sufficienflengih of pipe
to conduct the
ga..s{:!s outside the enClosure, and the mufflertothepipe

Onan CCK Series Specifications

General

Brand	Onan
Model	CCK Series
Category	Portable Generator
Language	English