19
Setting the Clock
You can select either the 12-hour or 24-hour display. (This section explains how to set the time
based on the 24-hour display.)
To cancel the clock setting
Press EDIT/NO/CLEAR.
To check the time and the day of the week, press
CLOCK on the remote controller.
Press DISPLAY while the current time is indicated on
the display.
First turn on the power to the unit, then press and hold
down the STANDBY/ON button for more than two sec-
onds.
To cancel the current time indication, press and hold
down the STANDBY/ON button for more than two sec-
onds while the power is on.
DISPLAY
DISPLAY
button
EDIT/
NO/CLEAR
1
2-6
1
Press TIMER repeatedly until
“Clock” appears in the display.
2
Press MULTI JOG.
You can now set the day of the week.
3
Turn MULTI JOG to select the cur-
rent day of the week.
4
Press MULTI JOG to confirm the
setting.
You can now set the time.
5
Turn MULTI JOG to set the cur-
rent time.
You can also use the number buttons
on the remote controller.
To switch between the am and pm indi-
cators, press the --/--- button on the
remote controller.
6
Press MULTI JOG to start the clock.
You can also use the ENTER button on
the remote controller.
It can be helpful to synchronize with an
accurate time source.
The clock starts operating and a dot
indicating seconds starts to flash.
Checking the time and the day of the
week
To switch between the 12-hour and 24-
hour displays
To display the current time while the unit
is in Standby mode
CLOCK
The clock appears for eight seconds in Standby mode.
To Next Page
Need help?
General
