5.Wireless network setup (applicable to Wi-Fi models)
1. Access point (wireless router)
2.
Wireless network printer
3.
4.
Computer connecting to access point
via network cable
Wi-Fi Direct mode: wireless client is connecting
to a printer with Wi-Fi function
1.
Wireless network printer
2.
Wireless client is directly connecting to a
wireless network printer
5.1.Basic structure mode
5.1.1.Wireless network setup tools
1. Access point (wireless router).
2. A computer that has been connected to network.
3. A printer that has wireless network function.
4.USB Interface Cable.
Wireless network connection type is divided into basic structure mode and
Wi-Fi Direct mode. If you have problems with wireless network setup, please
refer to Chapter 5.3 Wireless Network Setup FAQs.
Computer connecting to access point
via wireless network
Basic structure mode: connecting to a wireless
device via router
You can connect a computer to your printer via access point (wireless router)
as the medium. Access point (wireless router) connection is divided into wireless
network setup and Wi-Fi Protected Setup (WPS).
Important: Before wireless network installation, you must learn about the service
set identifier (SSID) and password of your access point in order to use them during
wireless network setup. If they cannot be determined, please consult your network
administrator or access point (wireless router) manufacturer.
5.1.1.1.Preliminary preparations
If your computer has been installed with a driver and had been connected
to wireless network, but the wireless network was changed, you can set it
again with wireless network setup tools.
To Next Page
Loading...
Need help?
General