9.2.Network Settings
You can check or set network status via network setting.
1) Press "Menu" to enter the Menu Settings interface.
2)
Press direction key “▲” or “▼” and select “3. Network Set” option and press “OK”
key to set “Wired network setting”, “wireless network setting” and “Wi-Fi Direct”.
Note：
• To set IP address, subnet mask and gateway, press direction key “▲” to
circularly accumulate values from “0-9”, press direction key “▼” to circularlly
input the position from left to right, press “OK” key to save setting and press
“Return” key to return to the previous menu.
Note: Set auto off condition:
•
Shutdown under no-port state (default configuration): no port is connected,
Wi-Fi function deactivated, printer is under standby or sleep mode.
•
Shutdown under idle state: the printer is under standby or sleep mode.
• If auto off condition is satisfied, printer will be off at the preset time.
• After printer is off, power consumption is 0.5W or lower.
To Next Page
Loading...
Need help?
General