SUPERFLO® VST, SUPERFLO
®
VS and SUPERMAX® VS Variable Speed Pumps Installation and User’s Guide
13
Factory Reset
The drive can be reset to factory settings if necessary.
A Factory Reset will erase all programmed settings
and schedules, except for the time of day. Be sure
that it is necessary before performing a Factory
Reset, as the results are immediate.
Note: Factory Reset can not be performed when in
Keypad Lockout mode.
TO PERFORM A FACTORY RESET:
1. If the pump is running, press the Start/Stop button
to stop the pump.
2. Record all of the custom schedule settings in
Table 3. You can nd these settings by pressing
the “1”, “2”, 3, and Quick Clean buttons and
cycling through all the screens.
3. Record the programmed Priming Speed in Table 3.
4. Press and hold “1”, “2”, “3” and Quick Clean for 3
seconds.
5. “FAct rSt” will display if factory reset is successful. See
Figure 16.
6. Reprogram the schedule and priming speed as described
in the previous sections.
The pump must be turned back on with the Start/Stop
button before it will run again. The pump will run the
programmed schedule upon initial start-up.
Speed
(RPM)
Duration
(Hours)
Start Time
(Time Clock)
SPEED 1
SPEED 2
SPEED 3
QUICK
CLEAN
Priming
Speed
Table 3
Figure 16
FACt
r5t
To Next Page
Loading...
Need help?
General
