THE ALARM SYSTEM
Setting and deactivating the
alarm
The alarm completes the security
equipment for your vehicle. It offers
two types of protection.
• exterior protection: when it is set,
the alarm sounds if a door, the
boot or the bonnet is opened;
• interior protection: when it is set,
the alarm sounds if the sensors
detect a variation in the air move-
ment inside the vehicle (break-
ing of a window) or movement
inside the vehicle.
The alarm is also equipped with an
anti-tamper function.
If an attempt is made to tamper with
the wires to the siren, control unit or
the battery, the alarm is triggered:
the siren sounds and the headlamps
come on.
Setting the alarm
(interior and exterior protection)
Switch the ignition off and get out
of the vehicle.
Press the locking button of the
remote control key.
The doors lock.
The direction indicators light for two
seconds.
The red light on the switch flashes
once a second.
5 seconds later, exterior protection is
set.
50 seconds later, interior protection
is set.
Note: when the alarm is triggered,
the siren sounds for thirty seconds.
After the thirty seconds it stops, but
the alarm remains set.
Warning: If, on setting the alarm, a
door, the boot or the bonnet are not
closed correctly, the siren sounds for
a moment. If the vehicle is closed
correctly in the following 45 seconds,
the alarm is set and the direction
indicators remain on for two
seconds. In all cases, the alarm is
set after 45 seconds.
Disarming the alarm
(interior and exteriorl protection)
Press the unlocking button of the
remote control key.
The doors unlock.
The direction indicators flash for two
seconds.
The red warning light on the switch
goes out.
Note: if the warning light continues
to flash after disarming the alarm, it
is a sign that the alarm has been trig-
gered. The flashing will stop when
the ignition is switched on.
SPECIAL FEATURES
135
01-07-2002
To Next Page
Loading...
Need help?
General
