YOUR 406 COUPE IN DETAIL
85
Changing the battery of the
remote control
The information 'battery flat' is
given by an audible signal accompa-
nied by a message on the
multi–function display.
To replace the battery, unclip the
casing using a coin at the ring
(CR2016/3 volt battery).
If the remote control does not work
after the battery has been changed,
reprogramme the remote control.
Confidential card
The confidential card contains the
identification code necessary for any
work carried out by a PEUGEOT
dealer on the system. This code is
hidden by a film, which should be
removed only if necessary.
Keep your card in a safe place,
never inside the vehicle.
Reprogramming
the remote control
☞ Switch off the ignition.
☞ Switch the ignition on again.
☞ Press button A immediately.
☞ Switch off the ignition and remove
the remote control key from the
ignition. The remote control is now
working again.
Key in ignition
A buzzer sounds on opening the dri-
ver's door, if the key has been left in
the ignition.
Locating your car
To locate your car, if you have locked
it, in a car park:
☞ press button A. The courtesy
lights come on and the direction
indicators flash for a few seconds.
01-07-2002
To Next Page
Loading...
Need help?
General
