MAINTENANCE OF YOUR 406 COUPE
35
CHANGING A BULB
1 - Dipped beam headlamps
2 - Main beam headlamps
Two bulbs (H7-55W).
- Remove the red plastic cover.
- Press the tab and remove the protective cover corresponding to the faulty bulb.
- Disconnect the connector.
- Press the end of the securing clip to remove it. Change the bulb.
- When fitting, ensure that the direction notches are positioned correctly and that
the securing clip is corrrectly fixed.
- Reconnect the connector.
- Replace the protective cover.
3 - Side lights (W 5 W)
Turn the socket using the lever and remove it. Change the bulb.
4 - Direction indicators (PY 21 W)
Turn the bulb holder a quarter turn and remove it. Change the bulb.
Notes: only handle H7 bulbs using a dry cloth.
To replace the left-hand bulbs, remove the battery protective cover.
Direction indicator repeater
(W 5 W)
- Pull the rear section of the transpa-
rent cover and release the assem-
bly.
- Turn the connector a quarter turn
and remove it.
- Change the bulb.
Amber bulbs must be
replaced by bulbs of iden-
tical specification and
colour.
In certain climatic conditions (low
temperatures, humidity), the pre-
sence of condensation on the
inside of the headlamp glass is
normal; it disappears a few
minutes after the lights switch on.
01-07-2002
To Next Page
Loading...
Need help?
General
