SERVICE OPERATIONS
27
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
- Remove the engine's oil filler cap/gauge.
- Wipe dry the filler cap/gauge and fit it back
but do not screw it into the filler hole.
- Remove the filler cap/gauge and check the
oil level.
- The oil level shall not be between the
minimum (A) and maximum (B) level marks
without exceeding the latter.
- Add oil if necessary.
Draining the relay box
The gearbox must be drained when the
engine is warm so that the oil will run
easier.
Put on protective gloves.
- Place the vehicle on its central stand on flat
ground.
- Remove the relay box filler cap (1).
Remove the drainage cap and its
seal (2) and allow the oil to drip into a
recipient.
- Insert the drain plug fitted with a new seal.
Tightening torque: 12 Nm.
- Pour the required quantity of oil
corresponding to the manufacturer's
standards into the filler hole.
Quantity: 0.12 l.
- Fit the filler cap (1).
Tightening torque: 12 Nm.
B
A
1
2
To Next Page
Loading...
Need help?
General
