PEUGEOT Kisbee Workshop Manual

POWER UNIT
68
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
When re-installing, the camshaft bearings, the rocker shafts and the contact between the
rockers and the valves shall well lubricated in order to avoid any risk of seizure when starting
the engine (Use lithium soap grease). Seals and valve stems must be lubricated.

Fitting the cylinder head
- Fit the 2 guiding pillars and the metal
gasket (6) on the cylinder.
- Fit the timing chain through the cylinder
head timing well.
- Install the cylinder head.
You must set the timing every time you remove the cylinder head when servicing.

Method for tightening the cylinder head
- Fit the 4 washers.
- Tighten the 4 nuts (1) and the 2 washer
screws (2) slightly.
- Torque the 4 nuts in a crosswise order to
18 Nm and the 2 washer screws to 8 Nm.
6
1
1
2

PEUGEOT Kisbee Specifications

General

Displacement	49.9 cc
Cooling System	Air-cooled
Fuel System	Carburetor
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Drum
Seat Height	780 mm
Front Tire	110/70-12
Rear Tire	110/70-12
Width	700 mm
Engine Type	4-stroke, single-cylinder
Transmission	CVT
Weight	85 kg
Power	2.6 kW