PEUGEOT Kisbee Workshop Manual

SERVICE OPERATIONS
37
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
- Squeeze the caliper holder in order to
remove the first brake pad (1).
- Remove the second brake pad (2).
- Remove the brake pad spring (3).
When refitting the brake pads, push the
piston all the way into its housing.
After refitting, actuate the brake levers
several times to bring the brake pads
against the brake disc.

Checking the brake fluid level
- Position the handlebars so that the master
cylinder will be horizontal.
- Check the brake fluid level and if necessary
top up in the master cylinder.
A. Maximum brake fluid level.
B. Minimum brake fluid level.
- Remove the handlebar front cover
(6 screw). See: Procedure 4. page 22.
- Remove the cover and the diaphragm from
the master cylinder (2 screw).
- Add brake fluid until it reaches the maximum
level.
3
2
1
A
B

PEUGEOT Kisbee Specifications

General

Displacement	49.9 cc
Cooling System	Air-cooled
Fuel System	Carburetor
Front Suspension	Telescopic fork
Front Brake	Disc
Rear Brake	Drum
Seat Height	780 mm
Front Tire	110/70-12
Rear Tire	110/70-12
Width	700 mm
Engine Type	4-stroke, single-cylinder
Transmission	CVT
Weight	85 kg
Power	2.6 kW