12
English
Caution: During disinfection with boiling water, prevent the bottle or other parts from
touching the side of the pot. This can cause irreversible product deformation or damage
that Philips cannot be held liable for.
1. Fill a household pot
with enough water to
cover all parts and place
all parts in the pot. Let
the water boil for
5minutes. Make sure the
parts do not touch the
side of the pot.
2. Allow the water to
cool down.
3. Gently remove the
parts from the water.
Place the parts on a clean
surface/tea towel or
drying rack to air-dry.
4. Store the dry items
safely in a clean,
protected area until
needed. Ensure that the
clean parts have air-dried
completely before
storing them to help
prevent germs and mold
from growing.
Using the breast pump
Assembling the breast pump
Make sure you have cleaned and disinfected the parts of the breast pump that come into contact with milk.
Warning: Be careful, when you have disinfected the breast pump parts by boiling
them, they can be very hot. To prevent burns, only start assembling the breast pump
when disinfected parts have cooled down.
Warning: Wash your hands thoroughly with soap and water before you touch breast
pump parts and breasts to prevent contamination. Avoid touching the inside of
containers or lids.
Check the breast pump kit parts for wear or damage before use and replace them if necessary.
Note: Correct placement of the cushion, silicone diaphragm and silicone tube is essential for the breast
pump to form a proper vacuum.
To Next Page
Loading...
Need help?
General
