PIAGGIO beverly 500 User Manual

Characteristic
Spark plug
•
NGK CR7EKB
•
Champion RG6YC
Electrode gap
0.7-0.8 mm
03_08
Removing the air filter (03_08)
Proceed as follows:
- Loosen the clamping screws and remove the air filter cover "D";
- Remove the filter element and clean it with water and shampoo; then dry it with a
clean cloth and slight blows of compressed air. Finally, immerse it in a mixture con-
taining 50% oil of the recommended type and 50% petrol.
Then gently squeeze the filter element between your hands, allow it to drip and then
refit it.
CAUTION
IF THE VEHICLE IS USED ON DUSTY ROADS IT IS NECESSARY TO CARRY OUT
MAINTENANCE CONTROLS OF THE AIR FILTER TO AVOID DAMAGING THE
ENGINE.
CAUTION
IN ORDER NOT TO DAMAGE THE VEHICLE PLASTIC COVERS CONTACT AN
AUTHORISED SERVICE CENTRE TO HAVE THE AIR FILTER CLEANED.
41
3 Maintenance

PIAGGIO beverly 500 Specifications

General

Engine Type	Single cylinder, 4-stroke
Displacement	493 cc
Fuel System	Electronic fuel injection
Front Tire	110/70 - 16
Length	2, 150 mm
Width	780 mm
Seat Height	790 mm
Maximum Torque	43 Nm @ 5, 500 rpm
Cooling System	Liquid cooled
Transmission	CVT
Front Suspension	Telescopic fork
Front Brake	Single disc
Rear Brake	240 mm disc
ABS	No
Rear Suspension	Dual hydraulic shock absorbers