Level check
- Rest the scooter on a flat ground and on the cen-
tral stand.
- Remove the brake pump cover as shown in the
figure.
- Check the brake fluid level by the special indica-
tor located on the pump, as shown in the figure.
N.B.
THE LEVEL TENDS TO DROP AS THE BRAKE PADS GET WORN, A MINIMUM LEVEL SHOULD
NOT BE REACHED. IF THE LEVEL IS TOO LOW, CHECK AND FIX THE SYSTEM SEALS, IF RE-
QUIRED. TOP UP THE PUMP RESERVOIR, IF REQUIRED, CONSIDERING THAT THE "MAX."
LEVEL MUST ONLY BE OBTAINED WITH NEW PADS.
Top-up
CAUTION
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID.
Proceed as follows:
- Rest the scooter on a flat ground and on the cen-
tral stand.
- Remove the brake pump cover as shown in the
figure.
Beverly 500 i.e. Maintenance
MAIN - 29