PIAGGIO X8 400 Euro 3 User Manual

Action
Crankcase breather - empty
AFTER 20,000 KM AFTER 40,000 KM AFTER 60,000 KM AND AFTER 80,000 KM
Action
Safety locks - check
Bushing of driven pulley
Spark plug - replacement
Driving belt - replacement
Throttle lever - adjustment
Air filter - check
Air filter belt compartment - check
Engine oil - change
Valve clearance - check
Electrical system and battery - check
Coolant level - check
Brake fluid level - check
Engine oil - replacement
Brake pads - check condition and wear
Sliding block / variable speed rollers - change
Tyre pressure and wear - check
Vehicle and brake test - road test
Hub oil - check
Idle speed (*) - adjustment
Centre/side stand joint - lubrication
Crankcase breather - empty
Suspensions - check
Steering - Check
Injection system pipework - visual check
Fuel filter - check
(*) See instructions in «Idle speed adjustment» section
Spark plug
Proceed as follows:
1. Remove the lid to access the spark plug and
reach it with your hand;
2. Disconnect spark plug HV wire cap «A» ;
3. Unscrew the spark plug using the spark plug
wrench supplied;
4. When refitting, place the spark plug into the hole
at the required angle and tighten by hand until it is
finger tight;
5. Use the wrench only for final tightening of the
spark plug;
6. Place hood "A" fully over the spark plug.
N.B.
USING SPARK PLUGS OTHER THAN THE INDICATED
TYPE OR SHIELDLESS SPARK PLUG CAPS CAN CAUSE
ELECTRICAL SYSTEM FAILURES.
THE SPARK PLUG MUST BE REMOVED WHEN THE EN-
GINE IS COLD. SPARK PLUG REPLACEMENT OPERA-
Maintenance X8 400 Euro 3
MAIN - 32

PIAGGIO X8 400 Euro 3 Specifications

General

Brand	PIAGGIO
Model	X8 400 Euro 3
Category	Scooter
Language	English