Reassembly of steering tapered bearing seats
Using the special tool, reassemble the tapered
bearing housings on the head as described below:
- Place a new top housing on the head and a new
bearing seat on the bottom side.
- Insert the screw of the special tool set-up with the
adapters for inserting bearing and seat, into the
steering head, as shown in the figure.
- Using two 24 mm wrenches, tighten the screw to
move the two seats in abutment.
N.B.
ALWAYS USE A NEW BEARING AND A NEW SEAT.
Specific tooling
001330Y Tool for fitting steering seats
Rear
Removing the rear wheel
Remove the full muffler assembly.
- Remove the screw fixing the right-hand shock
absorber to the bracket
- Remove the cotter pin, the cap, the wheel axle
fixing nut and the outer one of the two spacers.
Suspensions X8 400 Euro 3
SUSP - 302
To Next Page
Loading...
Need help?
General