PIAGGIO X8 400 Euro 3 User Manual

Rear brake calliper
Removal
- Remove the left suspension bottom retainer and
lift absorber upwards.
- Remove the two rear brake calliper devices fas-
tening them to the support as shown in the photo-
graph.
N.B.
SHOULD THE BRAKE CALLIPER BE REPLACED OR
SERVICED, BEFORE REMOVING THE FITTINGS FIXING
THE CALLIPER TO THE SUPPORT BRACKET, LOOSEN
THE OIL HOSE FITTING AFTER HAVING EMPTIED THE
SYSTEM OF THE CIRCUIT BEING EXAMINED.
Overhaul
- Remove the rear brake calliper.
- Suitably hold the brake calliper in a clamp
- Remove the two calliper coupling screws as
shown in the photo
- Remove the two pistons from the calliper body
with the aid of short blasts of compressed air
through the brake fluid holes
- Remove the dust ring and the O-ring of each half
calliper.
- Remove the O-rings in the half calliper.
N.B.
WHEN REMOVING THE O-RINGS, BE CAREFUL NOT TO
SCRATCH THE HALF CALLIPER SEATS
Braking system X8 400 Euro 3
BRAK SYS - 308

PIAGGIO X8 400 Euro 3 Specifications

General

Brand	PIAGGIO
Model	X8 400 Euro 3
Category	Scooter
Language	English