En
7
01
Before you start
Checking what’s in the box
Please check that you’ve received the following
supplied accessories:
In case of SC-LX85
! Setup microphone (cable: 5 m)
! Omni-directional remote control (CU-RF100)
! RF adapter
! IR blaster cable x2
! AA/LR6 dry cell batteries x4
! AM loop antenna
! FM wire antenna
! iPod cable
! Wireless LAN converter (AS-WL300)
— Quick start guide
— CD-ROM (Operating instructions)
— Connecting cable
! Power cord
! CD-ROM (AVNavigator)
! Warranty card
! Quick start guide
In case of SC-LX75
! Setup microphone (cable: 5 m)
! Remote control unit
! AAA size IEC R03 dry cell batteries (to confirm
system operation) x2
! AM loop antenna
! FM wire antenna
! iPod cable
! Wireless LAN converter (AS-WL300)
— Quick start guide
— CD-ROM (Operating instructions)
— Connecting cable
! Power cord
! CD-ROM (AVNavigator)
! Warranty card
! Quick start guide
Installing the receiver
! When installing this unit, make sure to put it
on a level and stable surface.
! Don’t install it on the following places:
— on a color TV (the screen may distort)
— near a cassette deck (or close to a device that
gives off a magnetic field). This may interfere
with the sound.
— in direct sunlight
— in damp or wet areas
— in extremely hot or cold areas
— in places where there is vibration or other
movement
— in places that are very dusty
— in places that have hot fumes or oils (such as
a kitchen)
Loading the batteries
In case of SC-LX85
In case of SC-LX75
The batteries included with the unit are to check
initial operations; they may not last over a long
period. We recommend using alkaline batteries
that have a longer life.
WARNING
! Do not use or store batteries in direct sunlight
or other excessively hot place, such as inside a
car or near a heater. This can cause batteries to
leak, overheat, explode or catch fire. It can also
reduce the life or performance of batteries.
CAUTION
Incorrect use of batteries may result in such
hazards as leakage and bursting. Observe the
following precautions:
! Never use new and old batteries together.
! Insert the plus and minus sides of the
batteries properly according to the marks in
the battery case.
! Batteries with the same shape may have
different voltages. Do not use different
batteries together.
! When disposing of used batteries, please
comply with governmental regulations or
environmental public institution’s rules that
apply in your country/area.
Operating range of remote
control unit
The remote control may not work properly if:
! There are obstacles between the remote
control and the receiver’s remote sensor.
! Direct sunlight or fluorescent light is shining
onto the remote sensor.
! The receiver is located near a device that is
emitting infrared rays.
! The receiver is operated simultaneously with
another infrared remote control unit.
30°
30°
7 m
Note
By connecting an RF adapter to the RS-232C
and CU-RF100 terminals (SC-LX85) /
EXTENSION terminals (SC-LX75), the CU-RF100
omni-directional remote control can be used for
RF two-way communications with the receiver.
With RF two-way communications, the informa-
tion of the receiver’s display can be displayed
on the remote control in your hands and the
remote control can be operated without worry-
ing about obstacles or the direction in which
the remote control is pointing. For details, see
Flow for operating the receiver with RF two-way
communications on page 7.
! The RF adapter and CU-RF100 omni-
directional remote control are included with
the SC-LX85, sold separately with the SC-LX75.
! The maximum line-of-sight distance for RF
two-way communications is about 10 meters.
This line-of-sight communications distance is
a rough indication, and may differ according
to the surrounding environment.
Flow for operating the
receiver with RF two-way
communications
SC-LX85 only
This remote control unit is set for operations
using infrared signals upon shipment from
the factory. To set it for RF operations, take the
steps below.
1 Connecting the RF adapter to the RS-
232C and CU-RF100 terminals.
! Connecting the RF adapter on page 15
2 Setting the ‘RF Remote Setup’ to ‘ON’.
! RF Remote Setup on page 92
3 Pairing the RF adapter and remote
control.
! Pairing the RF adapter and remote control on
page 71
To Next Page
Loading...
Need help?
General
Weight and Dimensions
