8.8
9930588 R02 - 2017-2020 RZR 900 900/S 900/S4 1000/S 1000/S4 Service Manual
© Copyright Polaris Industries Inc.
7. Apply Loctite® 603™ retaining compound to the
outer circumference of the new bearing race
w
and
carefully press the new bearing into the bearing
carrier housing
e
.
NOTICE
Use care to not allow any of the Loctite® compound to
get in the bearing.
8. Wipe the housing clean of any excess compound and
install the snap ring
r
.
REAR BEARING CARRIER
INSTALLATION
1. Install drive shaft through the back side of the bearing
carrier.
2. Install the fasteners
q
that attach the upper and
lower control arms to the bearing carrier. Torque bolts
to specification.
TORQUE
Rear Bearing Carrier Mounting Fasteners:
42 ft-lb (57 Nm)
3. Apply a small amount of anti-seize to the drive shaft
splines.
FINAL DRIVE
To Next Page
Loading...
Need help?
General
