Polaris RZR XP 1000 2018 User Manual

2.60
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
SPARK PLUG SERVICE
Inspect and replace the spark plugs at the intervals
outlined in the Period Maintenance Chart.
1. Remove the cargo box access panel
q
.
WARNING
A hot engine can cause serious burns. Allow engine to
cool or wear protective gloves when removing the spark
plugs.
2. Remove both spark plug caps
w
.
NOTE
Note MAG and PTO reference decals on spark plug
wires for reassembly.
3. Clean out plug wells with compressed air to remove
any loose dirt or debris.
4. Rinse plug wells with water and dry with compressed
air.
NOTE
Spark plug wells have drain holes built into the cylinder
head to allow water to drain out.
5. Remove spark plugs using a 5/8” spark plug socket
with an extension.
6. Inspect electrodes for wear and carbon buildup. Look
for a sharp outer edge with no rounding or erosion of
the electrodes.
7. Clean with electrical contact cleaner or a glass bead
spark plug cleaner only.
CAUTION
A wire brush or coated abrasive should not be used.
8. Measure gap with a wire gauge. Adjust gap if
necessary by carefully bending the side electrode.
9. If necessary, replace spark plug with proper type.
CAUTION
Severe engine damage may occur if the incorrect spark
plug is used.
Recommended Spark Plug:
NGK MR7F / 0.7-0.8 mm
10.Install spark plugs and torque to specification.
TORQUE
Spark Plug Torque:
7 ft-lbs (10 Nm)
11. Install the plug caps to the appropriate cylinder by
referencing the MAG and PTO spark plug wire
decals. Ensure wires are pushed down all the way so
they engage onto the spark plugs.
12.Reinstall the cargo box access panel.
MAINTENANCE

Polaris RZR XP 1000 2018 Specifications

General

Brand	Polaris
Model	RZR XP 1000 2018
Category	Automobile
Language	English