Polaris RZR XP 1000 2018 User Manual

6.14
9928492 R04 - 2017-2018 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
25.Install the stabilizer bar link mounting bolts and new
nuts
f
. Torque to specification.
TORQUE
Stabilizer Bar Linkage:
40 ft-lbs (54 Nm)
26.Safely lower the vehicle.
27.If transmission lubricant was drained, fill the
transmission with the specified amount of Polaris
AGL (see Chapter 2 – Transmission Lubrication,
page 2.48).
FLUID CAPACITY
Recommended Transmission Lubricant:
AGL
Capacity (Standard):
44 oz (1300 mL)
Capacity (INT’L):
40.5 oz (1200 mL)
TRANSMISSION VENT LINE ROUTING
The transmission vent line connects to a nipple
q
on the
side of the transmission near the transmission switch.
The vent line routes up through the gap between the
MAG and PTO intake runners and is retained by a clip
w
mounted to the cargo box rear bracket.
The line runs parallel with the fuel supply line and is
retained by a zip tie
e
attached to the cargo box front
bracket. The line terminates to open air (does not
terminate to a fitting or hole in the frame).
TRANSMISSION DISASSEMBLY
NOTE
Refer to the exploded view at the end of this chapter as
a reference.
1. Place transmission in High gear before disassembly.
2. Drain and properly dispose of the transmission
lubricant (see Chapter 2).
TRANSMISSION

Polaris RZR XP 1000 2018 Specifications

General

Brand	Polaris
Model	RZR XP 1000 2018
Category	Automobile
Language	English