3
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
3.27
10. Remove the outer clutch cover screws
w
and
remove the cover from the vehicle.
11. Remove drive belt, drive clutch, driven clutch, inner
clutch cover and clutch outlet duct (see Chapter 5 –
PVT Disassembly (2014–2015), page 5.11).
CAUTION
Correct Drive Clutch Puller P/N 2872085
NOTE
Be sure to use the correct Drive Clutch Puller (PN
2872085) to prevent damage to crankshaft.
12. Disconnect the TMAP sensor
e
, fuel injector
harness leads
r
, CPS
t
, ECT sensor
y
, and
ignition coil harness lead. Remove wire ties retaining
harness to the fuel rail and rear cross member.
13. Disconnect the stator harness.
14. Remove (+) positive cable from the starter motor.
15. Remove (-) negative cable from the starter mounting
bolt.
16. Disconnect fuel lines and remove throttle body
assembly (See Chapter 4 – Fuel Line Removal /
Installation, page 4.17 Fuel Line Removal /
Installation, page 4.17Throttle Body Removal, page
4.34). Make note of line routing for installation.
17. Remove spark plug wires from the engine.
NOTE
The spark plug wires are marked with MAG and PTO.
Note during installation procedure.
18. Remove the breather hose
u
from the crankcase.
ENGINE / COOLING SYSTEM
To Next Page
Loading...
Need help?
General
