10
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
10.21
8. Remove the dash assembly from the vehicle.
NOTE
The lower dash is also held by clips. Pull the dash
straight out to disengage the clips..
Front Fender Flair Removal
9. Remove the six T40 Torx screws and remove fender
flairs
q
from the dash assembly.
NOTE
Two of the screws will be longer than the others. Note
this for reassembly.
Front Body
10. Remove the hood, upper dash and fender flairs as
previously stated.
11. Remove the two T-40 Torx screw that were hidden
beneath the fender flair (one on the outside of the
fender and one on the inside).
12. Remove the front portion of the cab frame assembly.
Refer to appropriate Cab Frame Assembly XP, page
10.3 procedure for assembly torque specifications.
13. Remove the front fender.
REAR FENDER / FENDER FLAIR REMOVAL
XP
Fender Flair Removal:
1. Remove the three Torx screws
q
.
2. Remove the four plastic rivets on the lower side of
the rear fender flare.
3. Remove the fender flair
w
from the vehicle.
Fender Removal:
4. Remove the PVT and/or Air Intake cover.
5. Remove the four plastic rivets (one of them hidden
on the inside) retaining the rear fender.
6. Remove the one T-40 Torx screw on the top rear of
the fender.
7. Remove the fender from the vehicle.
BODY / FRAME
To Next Page
Loading...
Need help?
General
