10.4
9926816 R07 - 2014-2016 RZR XP 1000 / XP4 1000 Service Manual
© Copyright Polaris Industries Inc.
CAB FRAME ASSEMBLY XP 4
NOTE
Finger tighten all components until cab frame is completely assembled on vehicle then tighten to specification.
1. Install the ROPS mid-hoop to the frame with M10 x 1.5 x 65 screws and nuts
q
. Torque to 40 ft-lb (54 Nm).
2. Install hip bolsters onto the main frame with M8 x 1.25 x 20 bolts
w
. Torque bolts to 14 ft-lb (19 Nm)
3. Install ROPS rear hoop to frame with M10 x 1.25 x 55 bolts and nuts
e
. Torque to 40 ft-lb (54 Nm)
4. Attach ROPS main to the mid ROPS hoop and front main frame with M10 x 1.5 x 45 screws
r
. Torque to 40 ft-lb
(54 Nm).
5. Install rear ROPS to rear ROPS hoop and rear frame with M10 x 1.5 x 45 screws
t
. Torque to 40 ft-lb (54 Nm)
6. Install ROPS brace to ROPS mid hoop and ROPS rear hoop with M10 x 1.5 x 45 screws
y
. Torque to 40 ft-lb (54
Nm)
7. Install ROPS front to ROPS mains with M10 x 1.5 x 20 screws
u
. Torque to 40 ft-lb (54 Nm)
8. Install visor panel on front ROPS with M10 x 1.25 x 20 bolts. Torque to 8 ft-lb (11 Nm)
BODY / FRAME
To Next Page
Loading...
Need help?
General
