EasyManuals Logo
Home>Polaris>Offroad Vehicle>SCRAMBLER 90

Polaris SCRAMBLER 90 User Manual

Polaris SCRAMBLER 90
109 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
GENERAL INFORMATION
1.11
2003 MODEL YOUTH ATV
SPEED
RESTRICTION
Per ANSI / SVIA--1--2001 (sec. 6.1.3)
AS DELIVERED TO THE CONSUMER:
The speed of youth models is restricted
to under 10 MPH for the 50 cc models
and under
15 MPH for the 90 cc models.
The dealer
CANNOT, under any circum-
stances, either prior to the sale or later
,
even at the consumers request
,re-
move or adjust any speed limiting device
These are to be adjusted/removed only
by the consumer. Speed limiting devices
can only be removed or adjusted by th
e
consumer when they determine their
child is capable of the additional speed.
Per ANSI / SVIA--1--2001 (sec. 6.2) the
unrestricted top speed is less than 15
MPH for the 50 cc models and less than
30 MPH for the 90 cc models.
SPEED CONTROL SYSTEMS
Electronic Speed Control System
Your Polaris ATV is equipped withan electronic speed
control system, which controls the engine RPM and
speed of the ATV.
Speed can be adjusted by removing or installing the
jumper ontheCDI (A). Withthejumper installed, 50cc
models will travel no faster than 10 mph and 90cc
models will travel no faster than 15 mph. With the
jumper removed, 50cc models will travel no faster
than 15mph and 90cc models will travel no faster than
30 mph.
Jumper Removal and Installation
1. Remove the CDI and its rubber mounting strap
from the mounting tab, which is located on the
frame bulkhead near the steering post. It can be
accessed through the left front fender.
2. Remove the two screws (B) from the jumper to
remove or install the jumper. Reinstall the
screws.
3. Reinstall the CDI and mounting strap onto the
mounting tab.
A
B
SPEED CONTROL SYSTEMS
Throttle Stop Speed Control System
Adjusting speed at the CDI is the recommended
method of speed control, but the throttle stop system
may also be used. Use the following procedure to
control how far the throttle opens.
1. Loosen the jam nut (A)
2. Turn the screw (B) inward to reduce speed or
outward to increase speed.
3. Tighten the jam nut after adjusting.
A
B
Enfocus Software - Customer Support

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Polaris SCRAMBLER 90 and is the answer not in the manual?

Polaris SCRAMBLER 90 Specifications

General IconGeneral
BrandPolaris
ModelSCRAMBLER 90
CategoryOffroad Vehicle
LanguageEnglish

Related product manuals